2. WIRING
2-68
How to open the [INSTALLATION SETTING] menu
Turn off the monitor unit. While you hold the DISP key, press the BRILL key to turn on
the monitor unit. Keep the DISP key pressed until the [INSTALLATION SETTING]
menu appears.
Note: When the [DVI PWR SYNC] slide switch is ON, turn on the connected external
equipment while you press the DISP key to turn on the monitor unit.
2.10 LAN Signal Converter
The LAN Signal Converter allows the use of existing antenna cable RW-9600/6895/
4873 for TR-UP radar.
If the LAN Signal Converter is not attached in the antenna and Processor Units, the
required LAN Signal Converter Kit (available as an optional extra) is listed below.
For X-band radar only, you can select a specification with the LAN Signal Converter
pre-installed at the factory.
LAN Signal Converter Kit (option)
2.10.1 Application overview
The LAN Signal Converter has two applications.
Application 1: Use with existing antenna cable (retrofit)
Method 1: Using existing antenna cable (RW-9600/6895/4873)
Note: Use with existing antenna cable (RW-9600/6895/4873) in case of retrofit. The
maximum length of the antenna cable is 100 m for RW-9600, 50 m For RW-6895/
4873.
Radar Type Code No.
X-band magnetron radar OP03-247-3 001-496-580
X-band solid state radar OP03-247-4 001-568-890
S-band magnetron radar OP03-247-2 001-496-570
S-band solid state radar OP03-247-1 001-496-560
Antenna Unit side
Antenna cable
(Coaxial, Power)
* Installed inside respective unit.
Power
Processor Unit side
Power
Coaxial
Power
LAN
Processor
Unit
TB
LAN↔Coax
Converter*
Power
Power
LAN
RF-TB
LAN↔Coax
Converter*
Antenna
Unit
To Next Page
Loading...
