3. ADJUSTMENTS
3-24
• [SFI]: Set the SFI. The talker of the device is alphanumeric, two characters followed
by four numerals.
The device and channel information to be transmitted to VDR are shown below.
[RX SETTINGS]
Select [ON] to receive the following data signals:
• [MISC]: Other equipment data (sensor of engine etc.)
• [TGTD]: Target data
• [SATD]: Satellite data
• [NAVD]: Navigation data
• [TIME]: Time
• [PROP]: Specified data by manufacturer or user
3.5.10 [OTHER SETTINGS] menu
Open the main menu then select [RADAR INSTALLATION]o [NEXT]o[OTHER SET-
TINGS] to open the [OTHER SETTINGS] menu through two pages. On the page 1,
select NEXT to open the page 2..
[DEMO ECHO]
Select the type of simulated echo to use. [EG-3000] (Echo Generator), [TT-TEST],
[PC] or [EG-4000]. Select [OFF] to deactivate this feature (default: [OFF]).
Radar No. Device Channel Radar No. Device Channel
No.1 75 1
No.5 79 1
No.2 76 1
No.6 80 1
No.3 77 1
No.7 81 1
No.4 78 1
No.8 82 1
2
DEMO ECHO
OFF / EG-3000 /
TT-TEST / PC / EG-4000
IP: 192. 168. 031. 101
3
EAV W/O GYRO
OFF / ON
1
BACK
7
OVERLAY1
8
OVERLAY2
OTHER SETTINGS (1/2)
0
NEXT
4
ECDIS
OFF / SERIAL / LAN
5
EXT BRILL CONTROL
OFF / ON
6
SSD SUB OUTPUT
OFF / ON
2
RANGE UNIT
3
SHUTLE FERRY SWITCH
RS-232C/ AMS/ECDIS
1
BACK
INSTALLATION (2/2)
4
ECDIS ROUTE DISPLAY
NORMAL/ LEGACY
Page 1 Page 2
Go to page 2.
Go back to
page 1.
To Next Page
Loading...
