4-1
4. INPUT/OUTPUT DATA
4.1 Processor Unit
Input and output data are shown in the table below.
Note: This radar accepts position data fixed by WGS-84 geodetic datum only. Set the
datum to WGS-84 on the EPFS (GPS, etc.) connected to this radar. If other type of
datum is input, the error message "DATUM" appears and the AIS feature is inopera-
tive.
Input
*: Data input cycle must be more than 40 Hz (high speed craft) or 20 Hz (conventional
ships).
**: For C-type radars only
Data Specification Contents Remarks
Heading
signal
AD-10 format External AD-100 AD-10 and IEC 61162
are switched by menu
setting.
IEC 61162-2*,
IEC 61162-450
Speed
signal
IEC 61162-1,
IEC 61162-450
Navaid data IEC 61162-1 Position, course, speed,
waypoint, route, time,
wind data, current data,
depth, temperature, roll,
pitch
For IMO-type, IEC-
61162-1 Edition 5 is re-
quired.
IEC 61162-450
Alarm
handling
signal
Contact closure Input from bridge alert
management system
(BAMS)
IEC 61162-1,
IEC 61924-2
ACK, ACM, HBT Input from BAMS ACK
and ACM are switched
by menu setting.
AIS signal IEC 61162-2,
IEC 61162-450
Consort
signal**
NMEA0183
GPS buoy
signal**
NMEA0183
NOTICE
IMO-type radar(s) must be interconnected to the following type approved sensors.
For other radar types, it is recommended to connect the following type approved sensors:
•
EPFS meeting the requirements of the IMO resolution MSC.112(73).
•
Gyrocompass (or equivalent devices) meeting the requirements of the IMO resolution A.424(XI).
•
SDME meeting the requirements of IMO resolution MSC.96(72).
The radar may be interconnected via HUB-3000 to other FURUNO processing units having approved
LAN ports.
To Next Page
Loading...
