1. INSTALLATION
1-22
1.4.3 Installation of RCU-016 connected with RCU-014
1.4.4 How to change the cable entry of RCU-015/016
To change the cable entry from the side (default) to the bottom, modify the unit as
shown in the following procedure.
1. Turn the chassis upside-down and remove four screws (M3u8) to open the back
cover.
2. Remove the cable clamp, then remove the cable.
3. Pass the cable through the
hole in the figure shown in the
figure to the right, then clamp
the copper part of the cable
with the cable clamp removed
at step 1.
Note: If the RCU-016 is con-
nected in series with RCU-
015, connect J522 instead of
J521.
4. Close the back cover of RCU-
016.
2. Connect the
RCU-016 cable
connector to J502.
3. Clamp the copper
part of the cable with
the cable clamp.
1. Pass the cable from
RCU-016.
J52
4
J521
Screw (M3Ă—8)
Bottom of the unit
Screw
(M4Ă—8)
Remove the cable clamp .Remove the cable clamp .
J524
J521
Hole to pass
the cable.
J522
(for connection with RCU-015 )
To Next Page
Loading...
