Furuno FAR-2328 - 1.4.3 Installation of RCU-016 connected with RCU-014; 1.4.4 How to change the cable entry of RCU-015;016

1. INSTALLATION
1-24
3. Set the unit to the mounting hole, then secure the unit with four self-tapping
screws (520, supplied).
4. Attach four bolt hole caps (supplied).
1.4.3 Installation of RCU-016 connected with RCU-014
1.4.4 How to change the cable entry of RCU-015/016
To change the cable entry from the side (default) to the bottom, modify the unit as
shown in the following procedure.
1. Turn the chassis upside-down and remove four screws (M38) to open the back
cover.
Self tapping screw
(Ø5×20, 4 pcs)
Bolt hole cap
(4 pcs)
2. Connect the
RCU-016 cable
connector to J502.
3. Clamp the copper
part of the cable with
the cable clamp.
1. Pass the cable from
RCU-016.