1. INSTALLATION
1-16
3. Orient the FURUNO logo of the radiator to
the side with the sticker on the bracket. If re-
versely oriented, the radiator cannot be set
to the bracket. Set the radiator so the guide
pins fit into the guide holes on the radiator
bracket.
4. Attach the spring washers and the flat washers to the hex bolts and then coat the
threads of ten hex bolts (M10×25, supplied) with the supplied adhesive. Fix loose-
ly the radiator to the radiator bracket with the hex bolts. Remove the guide pins.
Note: If the guide pins remains on the antenna unit, they may fall down and lead
to an accident over time.
5. Tighten the 10 hex bolts (torque: 36.5 N•m) and then coat the bolt heads with the
supplied adhesive.
How to hoist the Antenna Unit
Attached four shackles (locally supplied) with two belt slings (approx. 4 m, locally sup-
plied) to the lifting fixtures (20) on the chassis, and then hoist the antenna unit. After
the antenna unit is hoisted in place, remove the shackles.
1. Subject the orientation of the
radiator parallel to the direc-
tion of both covers of the an-
tenna unit.
2. Attach four shackles to both sides of two belt slings. Attach the shackles to the four
lifting fixtures on the chassis so that the belt slings passes over the radiator.
Direction for
FURUNO logo
Sticker
Adhesive (Bolt threads) Adhesive (Bolt heads)
Cover
RadiatorRadiator
Cable entrance
Direction of covers
Shackles
(four pieces)
Lifting fixture
(four places)
Belt slings
(two pieces)
To Next Page
Loading...
