1. INSTALLATION
1-23
1. Prepare a cutout in the location as shown in the figure as below.
2. Set the Control Unit to the cutout.
3. Attach the flush mount fixtures to the Control Unit with four screws from the rear
side.
4. Screw the wing screw to each mounting plate and then insert hex. bolt to each
wing screw.
5. Fasten each wing screw and then fasten the hex. nuts as shown in figure below.
Side view of Control Units
Flush mount, using with panel (for RCU-014 only)
Use the optional flush mount kit OP03-245 to mount the control unit to a console panel
using with the panel. See the mounting procedure in the kit for details.
Flush mount, fixed at front (for RCU-031)
Note: For flush mounting, select a location where the surface is flat.
1. Make a mounting hole and drill four pilot holes in the mounting location, referring
to the outline drawing at the back of this manual.
2. Attach a ground wire (IV-1.25sq, supplied locally) to the ground terminal at the
bottom of the unit.
RCU-014
RCU-015/016
388 ±2 mm (153') 150 ±2 mm (59')
170 ±2 mm (67')
176 ±2 mm (69')
Ground wire
*
: Use the screw that is
preattached to the
ground terminal.
Ground screw*
To Next Page
Loading...
