Furuno FAR-2338-NXT - [OWN SHIP INFO] menu

3. ADJUSTMENTS
3-6
3.5.2 [OWN SHIP INFO] menu
Enter the length and width of the ship, and scanner, GPS antenna and conning posi-
tions, referring to the description and figure below.
Note: This radar uses [CONNING POSITION] for CCRP and [SCANNER POSITION]
for ANT as reference points for measurements and calculations. The commissioning
engineer should understand this point, and enter own ship information accordingly.
Open the main menu then select [RADAR INSTALLATION]o [OWN SHIP INFO] to
open the [OWN SHIP INFO] menu.
[LENGTH/WIDTH]
Enter the ship’s length and width (0 to 999, default: 0).
[SCANNER POSITION]
Enter the distance from the scanner to both bow and port (0 to 999, default: 0).
[EPFS1(2) ANT POSITION]
Enter the distance from the GPS antenna to both bow and port (0 to 999, default: 0).
If a 2nd GPS antenna is installed, enter its position in [EPFS2 ANT POSITION].
[CONNING POSITION]
Enter the distance from the conning position to both bow and port (0 to 999, default: 0).
L1
L1: Ship length
W1: Ship width
L2: Conning position (from bow)
W2: Conning position (from port)
L3: Scanner position (from bow)
W3: Scanner position (from port)
L4: GPS antenna position (from bow)
W4: GPS antenna position (from port)
W1
L2
W2
W3
W4
L3
L4
Example