3. ADJUSTMENTS
3-7
3.5.3 [SCANNER] menu
Open the main menu then select [RADAR INSTALLA-
TION]o [SCANNER] to open the [SCANNER] menu.
[SECTOR BLANK1(2)]
Set area(s) where to prevent transmission. Heading
must be properly aligned (see section 3.2) before set-
ting any blind sector. For example, set the area where
an interfering object at the rear of the antenna would
produce a dead sector (area where no echoes appear)
on the display. To enter an area, enter start bearing rel-
ative to the heading and dead sector angle. To erase
the area, enter 0 for both the [START] and [ANGLE]
sections. The setting range of [START] is 0° to 359°
(default: 000°) and [ANGLE] is 0° to 180° (default:
000°).
Note: Turn off a stern blind sector when adjusting the
PM gain, to display the echo from the performance monitor properly.
[HSC PASSWORD]
Enter password to active the [ANTENNA ROTATION] menu for HSC only.
Note: For the password, contact your local dealer.
If the password is correct, the [ANTENNA ROTATION] menu appears.
[ANTENNA ROTATION]
Note 1: When this menu appears in gray, it is not available. The antenna rotation
speed is fixed at 24 rpm.
Note 2: For 42 rpm of S-band radar, the High Speed Kit (type: OP03-248, available
as an optional extra) is required.
This menu appears only when the correct password is entered at [HSC PASSWORD].
Select [LO] for 36 rpm, [HI] for 42 rpm. [AUTO] sets the
normal rotation speed to 36 rpm and switches the rota-
tion speed to 42 rpm when the short pulse is selected
(default: [AUTO]).
[HSC RESET]
Select [YES] to close and reset the [ANTENNA ROTATION] menu. Rotation speed is
fixed at 24 rpm.
[ANTENNA SWITCH]
Select [OFF] at [ANTENNA SWITCH] to prevent antenna rotation. For [EXT], set on/
off from an external device (default: [ON]).
[ANT STOPPED]
For qualified technician. [ANT STOPPED] prevents transmission while the antenna is
stopped in STBY (default: [STBY]).
To Next Page
Loading...
