Furuno FAR-2338-NXT - Flush mount Installation (option)

1. INSTALLATION
1-14
Side view of control units
How to mount the unit flush with mounting surface
1. Drill four mounting holes of 5 mm diameter referring to the outline drawing at the
back of this manual.
2. Fix the control unit with four screws (M4) from the underside of the desktop. (The
M4 screws with a sufficient length for the thickness of the desktop should be pro-
vided locally.)
Control Unit RCU-014
Control Unit RCU-015/RCU-016
1.4.2 Flush mount Installation (option)
Note: For flush mounting in a panel, the mounting surface must be flat. Do not install
the unit on an uneven surface.
Flush mount, fixed at rear (for RCU-014/015/016)
Use the optional flush mount kit FP03-09870 to mount the control unit to a console
panel. See the outline drawing at the back of this manual.
KB fixing plate
Rubber Foot
F4
F3
F2
F1