2. WIRING
2-13
10. Position the cables so their armors lie beneath their respective cable clamps in the
cable entrance. Fasten the cable clamps.
11. Coat the hinge with the supplied adhesive for hinge waterproof then close the ca-
ble entrance cover. Fix the cable cover with four screws, then coat the screws with
the supplied adhesive.
12. Reconnect the performance monitor connector (J807) to the rear cover.
13. Check that the gasket on the front and rear covers is seated properly, then
close the covers. The torque for the fixing bolts must be 10.0 N•m.
Note 1: If it is necessary to open the front cover after installing the de-icer kit, re-
move the de-icer power cable from the locking wire saddle as shown in the follow-
ing figure, then detach the cover slowly to prevent damage to the heater element.
Note 2: For the de-icer, take care not to hit the heater elements on the chassis or
radiator. If the heater hits something, unfasten the fixing screws for the heater to
adjust the position of the heater. Then fix the heater again.
Cable clamp
Adhesive
Close
Cable entrance cover
Adhesive
Screw
FRONT
Remove the power cable from the locking wire
saddle to open the front cover.
Remove the power cable from the locking wire
saddle to open the front cover.
To Next Page
Loading...
