2. WIRING
2-23
3. Disconnect the coaxial cable and unfasten four bolts to enable removal of the RF
unit.
4. Remove the RF unit with the handle.
Note: Lay the unit on its side or on top of non-ferrous material, to prevent demag-
netization.
5. Unfasten the cable gland for the antenna cable and remove the gasket and three
flat washers and remove the protector.
6. Slide the cable gland,
the gasket and three
flat washers onto the
cable.
7. Push the flat washer
against the armor.
8. Trim the armor so that
it does not extend past
the flat washers.
9. Pass the antenna cable through the cable entrance.
If applicable, unfasten the appropriate cable glands and pass the sub monitor and
de-icer power cables through the cable entrance. Pass the cables through their
respective locking wire saddle.
10. All other cables are connected to the RF unit and should be pulled out of the chas-
sis after passing them through their respective cable entrances. The de-icer pow-
er cable is connected to the de-icer board as shown in step 14.
11. Apply the supplied adhesive to the threads of the cable glands, and then fasten it
tightly with the hook spanner wrench.
Note: Use the wrench of the correct size. If you do not have the hook spanner
wrench, contact your dealer.
Clockwise when
viewed from the stern
Clockwise when
viewed from the stern
HandleHandle
Remove four bolts.Remove four bolts.
Cable entry for antenna cable (Side view)
Gland
Remove
protector.
Flat washers
Gasket
Push the flat washer
against the armor.
GlandGland
GasketGasket
Flat washersFlat washers
Antenna cableAntenna cable
To Next Page
Loading...
