2. WIRING
2-25
14. DE-ICER INSTALLATION. See “De-icer Kit Installation Instructions” (for TR-UP
radar, C32-01313), issued separately, for the de-icer not fitted at the factory. If the
de-icer is not provided, go to step 12.
1) Remove four bolts then spread open
the right and left heater elements on the
front cover.
Note: Lift the elements slightly when
opening so as not hit the elements on
the bolts on the chassis.
2) Unfasten four bolts to open the front
cover. Remove the cover, being careful
not to hit the elements on the chassis or radiator.
3) Remove the RF unit then pass the de-icer power cable from the cable en-
trance.
4) Wrap the supplied spiral tube around the de-icer power cable, starting from
the crimp-on lugs. Set a locking wire saddle (supplied) at location (6) shown
REAR
TB804
Fasten shield
with clamp.
Fasten conductor
with screw.
NOTE: Do not use
crimp-on lug, to prevent
contact resistance from
increasing.
Remove
Loosen
TB803
(
B
)
(
B
)
(
C
)
Front cover w/de-icer,
inside view
DEICER Board (03P9573)
TB901
Voltage Setting
switch
[TEST] button
To Next Page
Loading...
