Furuno FAR-2338-NXT - How to connect the cables for S-band (TR-DOWN) radar

2. WIRING
2-35
1. Loosen four bolts on the rear cover to remove the rear cover. If the de-icer is al-
ready installed or will be installed, remove also four bolts on the front cover to re-
move the front cover.
Note: The cable for the performance monitor is connected between the rear cover
and the RF-TB Board in the antenna unit. Open the cover slowly to prevent dam-
age to the cable and connector.
2. Disconnect the performance monitor connector (J807) from the RF-TB Board.
3. Unfasten the cable gland for the serial cable (TTYCSLA-10) and remove the gas-
ket and three flat washers and remove the protector.
4. Slide the cable gland,
the gasket and three
flat washers onto the
cable.
5. Push the flat washer
against the armor.
6. Trim the armor so that
it does not extend past
the flat washers.
For de-icer installation
REARREAR FRONTFRONT
Performance
monitor
Performance
monitor
REARREAR
RF-TB board (03P9570)
J807 (performance monitor)J807 (performance monitor)
REAR
REAR
Cable entry for serial cable (Side view)
Gland
Gland
Remove
protector
Remove
protector
Flat washers
Flat washers
Gasket
Gasket
Push the flat washer
against the armor.
GlandGland
GasketGasket
Flat washersFlat washers
Serial cableSerial cable