Furuno FAR-2338-NXT - Intelligent HUB (Option); VDR Connection

2. WIRING
2-58
2.11 Intelligent HUB (option)
Secure the LAN cables to the cable clamps on the HUB-3000 with cable ties (sup-
plied).
2.12 VDR Connection
The processor unit has the DVI-I port or the LAN port for connection of a VDR.
2.12.1 DVI-I (Analog RGB) port connection
• Use the optional RGB cable (DVI-BNCX5+GND-L2.0) to connect the VDR.
• The DVI-D port and DVI-I port have their own circuits. This prevents interruption of
the radar picture shown on the main monitor connected to the DVI-D port, if a fault
condition occurs at the DVI-I port.
• The processor unit continuously outputs video signals from its DVI-D and DVI-I
ports. The operator cannot stop the output.
2.12.2 LAN2 port connection
• Connect a VDR complied to IEC-61162-450 standards to the LAN2 port.
• If the [VDR LAN OUTPUT] setting is set to [ON], the screenshot (JPEG-format) is
output every 15 seconds through LAN2 port. See “[VDR LAN OUTPUT]”on page 3-
19.
• The output image at the same resolution as the DVI-D port.
• The LAN2 port and DVI-D port have their own circuits. This prevents interruption of
DVI-D port, if a fault condition occurs at the LAN2 port.
No use.
Power port
Power Fail
LAN port
Ground wire
(IV-1.25sq.,
supplied)
DPYC-1.5
DPYC-1.5
To gateway network (ECDIS, radar, etc.)
Attach the supplied LAN caps to unused connector
holes to comply with waterproofing standard IPX2.
LAN cable
Cable clamp