Furuno FAR-2807 Series - Page 248

4.7 Setting of AD-100 or GC-10
4-45
Table 4.7.3(2/2) Setting List
SW 3
SW3-#1
(See Table 4.7.5)
NMEA Ver SW3-#1 OFF: Ver 1.5 / ON: Ver 2.0
SW3-#2 Baud rate SW3-#2 OFF: 4,800 bps / ON: 38,400 bps
Ver03, 04:
Talker name
SW3-#3 OFF: AG / ON: HE
SW3-#3
(Setting according
to the program)
Ver05:
Power-off function
SW3-#3 OFF: Disable / ON: Enable
Jumper: JP1 – JP7
JP1 Gyro type
#1, #2, #3 AC synchrous
#2, #3, #4 DC synchrous
#4, #5, #6 DC step
JP2 Stator voltage
#2 20 VAC to 70 VAC, 20 VDC to 100VDC
#1 40 VAC to 135 VAC
JP3 Rotor voltage
#2 20 VAC to 70 VAC
#1 40 VAC to 135 VAC
JP4
JP5
Operating voltage
- JP4-#2, JP5-#2
20 VAC to 45 VAC, 20VDC to 60 VDC
- JP4-#1, JP5-#1
30 VAC to 135 VAC, 40 VDC to 100 VDC
JP6
JP7
AD format data
TX interval
25 ms or 200 ms
Table 4.7.4
NMEA output Interval, Output Sentences and Baud rate
SW2 setting Function
SW2-#5 SW2-#6 Output interval Output sentence Baud rate
OFF OFF 1 s
HDT＋VHW
ON OFF 200 ms HDT
OFF ON 100 ms HDT
Depends on the
setting of SW3-#2.
ON ON 25 ms HDT Fixed at 38,400 bps
When 200 ms, 100 ms or 25 ms is selected for the output interval, the output sentence is HDT only.
When 25 ms is selected, the Baud rate is fixed at 38,400 bps.