4.9 Selection of NAV DATA Input: [OS POSN]
4-53
The setting of TTM OUTPUT and INS shown in the Table below is for running TTM
data over the LAN. It is not the setting for sharing NAV data.
Table 4.9.5 Sharing NAV Data via INS-2
Setting
No.1
(NAV Rx)
No.2
(NAV Rx)
No.x
(NAV Rx)
[OS POSN] -> 1. NAV AID
(GPS1/GPS2/LAN/INS)
INS
Note
INS
Note
INS
Note
[OS POSN] ->
3.SIO DATA LAN OUTPUT
(ON/OFF)
OFF OFF OFF
[INITIALIZE] ->6 -> 2.TTM
OUTPUT
(OFF/REL/TRUE)
Select
REL or TRUE
Select
REL or TRUE
Select
REL or TRUE
[INITIALIZE] -> 8 -> 5 INS
(OFF/SRIAL/LAN)
LAN LAN LAN
Note:
When inputting the POS data from INS to radars, set NAV AID setting to the INS in the
respective radars.
3. Sharing NAV data with No.x radar from INS and with No.2 radar from No.1 radar
This setting assumes that NAV data is outputted from INS through the LAN port.
Fig. 4.9.3 Example of LAN Connection-3
HDG data
HDG data
HDG data
HDG data
NAV(L/L, SPD) data
NAV(L/L, SPD) data
No.1 FAR- No.2 FAR-
HUB
LAN
INS
(ECDIS)
xx.xx.xxx S
xxx.xx.xxx E
No.x FAR-
xx.xx.xxx S
xxx.xx.xxx E
xx.xx.xxx S
xxx.xx.xxx E
LAN LAN
LAN
NAV data
NAV data
FAR
Input the HDG data for each
radar.
ECDIS
Input the HDG/NAV data.
To Next Page
Loading...
