Furuno FAR-2807 Series - Page 79

Contents
3
Chapter 4. System Setting ............................................................ 4-1
4.1 Optional Menus .........................................................................................................4-1
4.2 Overview of [FACTORY] Menu...............................................................................4-2
4.3 Overview of [INITIALIZE] Menu.............................................................................4-3
4.4 Initialize Setting.........................................................................................................4-13
4.4.1 CABLE ATT ADJ............................................................................................4-13
4.4.2 TIMING, MBS, RING SUPPRESSION..........................................................4-14
4.4.3 DEFAULT ANT HIEGHT, NEAR/MID/FAR STC CURVE ..........................4-15
4.4.4 ANT REVOLUTION ......................................................................................4-17
4.4.5 RADAR NO. .................................................................................................4-19
4.4.6 RADAR ...........................................................................................................4-20
4.4.7 Inter -switch.....................................................................................................4-21
1. [ANT-X] -> 9: INTER SW PRIORITY .......................................................4-21
2. Additional information for the Inter SW ......................................................4-21
3. Main operations for each function................................................................4-23
4.4.8 MODEL...........................................................................................................4-24
4.4.9 TYPE: IMO/A/B/C/W.....................................................................................4-25
4.4.10 PM GAIN ADJ..............................................................................................4-28
1. Procedure for adjustment..............................................................................4-28
2. Turning on the performance monitor............................................................4-29
4.4.11 OWN SHIP INFO..........................................................................................4-30
4.4.12 ARP PRESET................................................................................................4-31
1. Setting of TTM OUTPUT ............................................................................4-31
2. Setting of ARP PRESET ..............................................................................4-31
3. [ARPA SENSOR DATA] .............................................................................4-31
4.4.13 NETWORK ...................................................................................................4-34
1. Checking of IP address ...............................................................................4-34
2. Changing of IP address ...............................................................................4-35
4.4.14 INS ................................................................................................................4-38
4.5 Jumper Setting of Terminal Board.............................................................................4-39
4.5.1 Jumper of AIS port: [J655]..............................................................................4-40
4.5.2 Jumper of HDG Sensor Prot: [J656]. ..............................................................4-40
4.6 Setting of Monitor Unit .............................................................................................4-41
4.7 Setting of AD-100 or GC-10 .....................................................................................4-42
4.7.1 Setting List.......................................................................................................4-44
4.7.2 Location of Parts..............................................................................................4-47
4.8 Addition to the Memory Card I/F: CU-200...............................................................4-48
1. Setting...........................................................................................................4-48
2. Confirmation of IP address...........................................................................4-49