EasyManua.ls Logo

Furuno FAR-2807 Series - Page 85

Furuno FAR-2807 Series
563 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Contents
9
25. When the power is restarted immediately after turning the power off,
the ST-BY status starts within 3 minutes. ...............................................................8-6
26. What is the difference among the IMO, A, B, C and W types?
See page. 4-25. ........................................................................................................8-7
27. When the [1:HL OFF] key is pressed, the range ring and all marks disappear.
Is this normal? .........................................................................................................8-7
28. Where is the power switch of MU-201CR and MU-231CR located?
See page.7-74. .........................................................................................................8-7
29. The power cannot be turned on.
See page.6-25. .........................................................................................................8-7
30. NAV data is not inputted.
See page.4-27, 4-50, 6-9 to 6-16. ............................................................................8-7
31. Is there a priority order for NAV-data connecting ports on the TB board?
See page.6-11. .........................................................................................................8-8
32. The position and speed data displayed in red.
See page.3-4 and 6-12. ...........................................................................................8-8
33. Show the list of error message.
See page.6-31. .........................................................................................................8-8
34. Show the manual method for CABLE ATT ADJ.
See page.4-13. .........................................................................................................8-8
35. The sensitivity (gain) has become lower.
See page.3-15, 4-28, 6-42 and 7-51. .......................................................................8-8
36. ARPA targets are quickly lost.
See page.4-8. ...........................................................................................................8-9
37. The antenna does not rotate on FAR-2837SW.
See page.4-24. .........................................................................................................8-9
38. The antenna rotation speed cannot be switched although RSB-097 is installed.
See page.4-68. .........................................................................................................8-9
39. Screen is blank even if the RCU-015 is turned on. ...................................................8-9
40. The [BRILL] box menu is not displayed. And the brilliance cannot be adjusted
even by turning the BRILL control.
See page. 4-41 and 7-73. ........................................................................................8-10
41. The monitor size and picture size does not match each other.
See page. 4-41 and 7-73. ........................................................................................8-10
42. NMEA data is shared in the LAN connection.
See page. 4-51. ........................................................................................................8-10
43. The number of mark points .....................................................................................8-10
44. Can marks and lines created on GD-280 and GD-680 be used? .............................8-10
45. What can be saved on a memory card CU-200?
See page.6-45 to 6-47. ............................................................................................8-10
46. How to erase the MARK. ........................................................................................8-11
47. How to display echoes in color
See page.3-17 and 4-25. .........................................................................................8-11
48. How to create the NAV line
See Chapter 5 of the Operator’s Manual. ...............................................................8-11
49. The NAV LINE from GPS cannot be displayed. .....................................................8-11

Table of Contents

Other manuals for Furuno FAR-2807 Series

Related product manuals