Furuno FAR-28x7 Series - Saving Plotter Data to Card

5. VIDEO PLOTTER OPERATION
5-36
[CARD (1/2)]
1 BACK
2 DRIVE SELECT
A/B/C/D*
3 [READ CARD]
4 [WR MARK]
5 [WR NAV LINE•WPT]
6 [WR OWN TRACK]
7 [WR TARGET TRACK]**
8 [WR SETTING DATA]
9 [WR INSTALL DATA]
0 NEXT
6. Roll the wheel to choose 0 NEXT and then push the wheel or the left button.
CARD menu, page 2
7. Roll the wheel to choose 3 CARD INITIALIZE and then push the wheel or the
left button.
CARD INITIALIZE menu
8. Roll the wheel to choose 2 INITIALIZE START and then push the wheel or
the left button to initialize the card. The LED near the card flashes, the CARD
menu disappears and the message “FORMAT CARD” appears.
5.14.2 Recording data
When the memory becomes full, the oldest track is erased to make room for the
latest. Further, when the memory is full you cannot enter another mark or line
unless you erase unnecessary marks, lines or track. Thus you should save
important data to a memory card so as not to lose important data.
1. Insert initialized memory card into appropriate drive in Card I/F Unit.
2. Roll the trackball to choose the MENU box and then push the left button.
3. Roll the wheel to choose 6 [CARD] and then push the wheel or the left
button.
CARD menu
[CARD (2/2)]
1 BACK
2 [FILE DELETE]
3 [CARD INITIALIZE]
[CARD INITIALIZE]
1 BACK
2 INITIALIZE START
* Drives available are shown.
** Not available on IMO type