11. Route Monitoring
11-3
11.3 Choosing Final Waypoint
Normally you use the last waypoint in a monitored route as the final waypoint, and the chart radar automatically
does this when you choose the route to monitor. However, sometimes you can prefer to use some other waypoint as
the final waypoint of a monitored route.
To choose a waypoint as final waypoint, do the following:
1. Open the Monitor Route dialog box; choose Route from the status bar, then click the Monitor button.
2. Place the cursor in the Final WPT box, spin the scrollwheel to choose a waypoint.
3. Push the scrollwheel to confirm your selection.
11.4 Viewing Waypoint Information
You can view waypoint information for the monitored
route by clicking the Waypoints tab in the Monitor
Route dialog box. This information is printed from route
planning information made for this voyage.
"TO WPT" and "NEXT WPT" are indicated on this list.
ETD
ETA
Speed limit
setting
WPT
WPT
LAT
LON
SPD CSE M
Rad
NAME
Planned ETA (UTC+1)
To Next Page
Loading...
