Furuno FCR-2107 series - Resetting Position Alignment

15. Navigation Sensors
15-13
15.6.3 Resetting position alignment
To reset position alignment, proceed as follows:
1. Open the Sensors dialog box then open the Position page.
2. Uncheck "Chart Align".
.
3. Check that the indication OFFSET is not shown in the upper part of the information area, to the right of the
position source indication.
HDG  071.0 ° 
SPD(WAT) 15.6 kn
SB (POSN)0.0 kn
COG(POSN)071.0
°
SOG(POSN)15.6 kn
59 ° 31.206’N
024
° 36.731’E
WGS 84
DGPS