Furuno FCR-2107 series - Anchor Watch; Introduction; Activating Anchor Watch

18-1
18. Anchor Watch
18.1 Introduction
Anchor watch checks to see if your ship is drifting when it should be at rest. Set the limit for anchor watch on the
menu. If your vessel drifts more than the distance set, the alert "874: Anchor watch" appears.
Your ship's position, where
you start the anchor watch.
Alarm
setting
: Alarm triggered
18.2 Activating Anchor Watch
To activate the anchor watch, do the procedure shown below.
1. Open the main menu.
2. Select Anchor Watch.
3. Enter desired value in the Drag circle field.
4. Drop the anchor then click the Drop Anchor button. The Start Anchor Watch
button appears (below the Clear Anchor button).
5. To start the anchor watch, click the Start Anchor Watch button.
If your vessel travels more than the distance set here, the alert "874: Anchor watch"
appears.