16. NAVIGATION SENSORS
16-3
SPD page
Stabilization Mode: Select the water stabilization mode: Select [Bottom] for ground
stabilization, or select [Water] for sea stabilization.
Sensor Type: Select [GPS] in case of a GPS navigator, or [LOG] for speed log.
Data Source: Check [Sensors] to use a sensor in the [Sensors] list, or click [Manual]
to enter speed manually. Use [Manual] when no speed source is available.
Manual: Input speed manually. Check [Water] in [Stabilization Mode] and deactivate
the AIS function to enable entry.
Reference SPD: Check to use radar as the source for speed and course. (Not avail-
able with the System Sensor Settings.)
Set and drift: Check the [Set Drift] checkbox to manually set speed and course of drift.
Note that you can select manual drift only if you deactivate the AIS function.
Angle = Difference between heading and COG
Spd = Speed component of the drift vector
Cse = Course component of the drift vector
Vector defined by (SOG and COG) is equal to vector sum of vectors defined by (SPD
and HDG) and (set and drift)
To Next Page
Loading...
