1. OPERATIONAL OVERVIEW
1-7
How to adjust the brilliance manually using the trackball module
1. Click the [BRILL] button on the InstantAccess bar to show the brilliance adjust-
ment window.
2. For coarse adjustment, put the cursor on a location within the slider bar area
then push the left button. For fine adjustment, put the cursor on the end of the
slider bar and roll the trackball while holding down the left button.
3. Release the left button to confirm setting. The calibration state indication changes
to "UNCALIB".
4. Click the [CALIB] button to calibrate the brilliance. The calibration state indication
changes to "CALIB".
1.4 Operating Modes
This chart radar has three operating modes:
• The radar mode provides the traditional radar display.
• The chart radar mode overlays the electronic chart on the radar image.
• The chart for radar mode shows the electronic charts.
1.4.1 How to select an operating mode
Click the [Operating Mode] button to select desired mode from the pull-down list. Se-
lect [ RADAR] for the radar or chart radar mode (see section 1.5.2), or [CHART for RA-
DAR] for the chart mode.
1.4.2 Limitations when using the chart radar mode
The presentation mode can be course-up RM, north-up RM, or north-up TM. The pre-
sentation mode is automatically switched to north-up RM if the mode is head-up at the
time the chart radar mode is selected.
[Operating Mode] button
To Next Page
Loading...
