1. MOUNTING
1-2
Mounting procedure
Desktop mounting
1. Loosen two M6 x 25 bolts at the front of the display unit to remove the mounting base.
M6 x 25 bolts
Removing the display unit from the mounting base
2. Use the four tapping screws (5 x 20, supplied as installation materials) to fasten the
mounting base.
3. Apply grease to the bolts removed at step 1.
4. Lay the display unit on the mounting base. Fasten the display unit to the mounting base
with the two M6 x 25 bolts greased at step 3.
To Next Page
Loading...
