3-7
3.4 Adjustment for Transceiver Unit, Video Sounder,
Telesounder, Picture Recorder
This section provides the settings necessary when connecting a Transceiver Unit (ETR-5D,
ETR-10D, etc.), Color Video Sounder, Telesounder (TS-30/507000/8000) or the Picture
Recorder MT-12.
Note 1: For the FCV-1200L, first install the EXIF board assy. See page 2-7.
Note 2: For the FCV-1200LM, only a master ship’s telesounder can be connected. Further, the
Picture Recorder MT-12 can only play back the echosounder signal; it cannot be used for
recording.
Transceiver unit, video sounder
1. Turn on the power.
2. Turn the [FUNCTION] switch to the MENU position.
3. Press [
] and [+] to select SYSTEM at the top of the screen.
DISP ALM TX/RX USER-1/2 SYSTEM
SYSTEM SETTING
ES/DRAFT SETTING
RANGE SETTING
TEMP SETTING
NET SONDE SETTING
USER COLOR SETTING
USER CLUTTER SETTING
NAV DATA SETTING
TARGET ECHO
STABILIZATION
TEST MODE
DEFAULT SETTING
[+]: Go to setting [EXIT (knob)]: Exit
Menu for system setting.
Figure 3-6 SYSTEM menu
To Next Page
Loading...
