3-8
4. Press [ ] to select E/S DRAFT SETTING, and then press [+] to open that menu.
DISP ALM TX/RX USER-1/2 SYSTEM
E/S DRAFT SETTING
<High Frequency>
XDCR CONNECT : INTERNAL
TX POWER : MAX
DRAFT : +0.0 ft (-15~+90)
FREQ CHOICE : **kHz
[-/+]: Change set, [EXIT (knob)]: Exit
Select transducer connected.
<Low Frequency>
XDCR CONNECT : INTERNAL
TX POWER : MAX
DRAFT :
+0.0 ft (-15~+90)
FREQ CHOICE : ***kHz
E/S SIG OUT : OFF
KP SETTING : INTERNAL
Figure 3-7 E/S DRAFT SETTING menu
5. Do the following for both the high and low frequencies, or whichever is installed.
a) Select XDCR CONNECT, and then press [+] to open the dialog box.
INTERNAL ETR TS/OTHER
b) Select INTERNAL or ETR referring to the table below, and then press [ ] or [ ] to close the
dialog box.
E/S DRAFT SETTING menu item
Equipment connected
XDCR CONNECT E/S SIG OUT
Transceiver Unit ETR OFF
External Video Sounder INTERNAL LF, HF, LF/HF
c) If the transceiver or external video sounder is to be used when vessel is in dry dock, select
TX POWER and press [+] to open the dialog box.
MAX 1/2 1/4 1/8 1/16 MIN
d) Press [+] to select appropriate power, and then press [ ] or [ ] to close the dialog box.
To Next Page
Loading...
