Set up before departure •
••
• 39
Route Monitoring menu
Select Route
Select a route for the next voyage. For more information selection of route, see Chapter "How to select route to be
monitored".
Select Next Waypoint
This informs which is the next waypoint for route monitoring and possible automatic route steering. The system
selects next waypoint automatically, check that it is correct one. Note that waypoint number 1 is not accepted. Use
above menu to do it.
Select Final Waypoint
This selection is used ONLY in case that the last waypoint should be different to that one defined last in your route.
If needed use above menu to do it.
Center line for ARPA radar
Select ON to display the center line of the route on the radar display. Displayed part of the route consists of one leg
before next waypoint and four legs after that. Select OFF to disable display of the center line on the radar display.
Channel borders for ARPA radar
Select ON to display the channel limit lines of the route on the radar display. Displayed part of the route consists of
one leg before next waypoint and four legs after that. Select OFF to disable display of the channel limit lines on the
radar display.
To Next Page
Loading...
