9. Raster Chart Material
9-15
9.4.6 Loading chart permits for ARCS Skipper license
Permits are usually delivered in a floppy disk. To load chart permit into the system, do the following:
1. Open the Chart menu, and then choose Chart Permits from the menu.
2. Choose Skipper license as the type of license. Insert a permit floppy disk in the floppy disk drive. Click the
Load File button.
3. Choose Gb.scp and then click the Open button.
4. Check in the Permit Management window that permits are displayed there with correct information. Close the
window by pressing the CANCEL key on the Control Unit RCU-018 or clicking the X on the window.
Note: If you are holding more than one ARCS Skipper packs onboard, only one pack can be loaded into the ECDIS
at a time. If you load a new ARCS Skipper permit floppy disk into the ECDIS, you must load charts and weekly
updates from CD ROMs delivered with and listed in your License Agreement (also known as “Schedule A”).
To Next Page
Loading...
