16. Pilot Data
16-8
16.5 Creating New Pilot Data
You can create and modify pilot data, and this can be done in the planning mode. It is recommended to use the true
motion display mode while editing.
3.1.
2.
[Pilot Data]
Go Monitor mode
Select
Unselect
Create
Backup and Restore
Report
Close
To create a new pilot data, do the following:
1. Place the cursor on PilotData in the status bar and then click the Plan button to show the Plan Pilot Data dialog
box. If you have not already chosen pilot data, the Plan Pilot Data menu also appears. If the menu is not
displayed, click the triangle mark again. Choose Create from the menu and then push the thumbwheel.
2. In the pilot name entry box, spin the thumbwheel to choose character, and then push the thumbwheel. Repeat to
enter name desired and then click the OK button.
3. In the Edit Record page of the Plan Pilot Data dialog box, check “Enable changes”. Roll the trackball to place
the cursor on the location desired for pilot data and then push the left mouse button. In the Range box, enter the
range from own ship at which to activate the pilot data. To show text message on the screen, enter desired
message in the text window; spin the thumbwheel to choose character and push the thumbwheel to confirm.
16.5.1 Adding new pilot data record
To add a new pilot data record the following choices are available:
• Using the left mouse button.
• Using the Add button in the Edit page.
To add a new pilot data record by using the left mouse button:
1. Open the Edit page of the Plan Pilot Data dialog box and check Enable changes.
2. Place the cursor on the location in the chart area where you want to add a new pilot data, and then push the left
mouse button. New pilot data record appears at the end of file.
3. Modify Range, Position, text message, etc. as appropriate.
To Next Page
Loading...
