18. Common Reference System
18-5
18.2.3 Shared user selections
The common reference system concept allows that some selections and settings made by a user in one workstation
are transferred to the other workstation. These are as follows:
• Route, user chart and pilot data in monitoring mode
• Chosen sensors in speed/course and position pages (including position alignment of own ship and gyro
correction) in the Sensors dialog box
• Settings for chart alarms and watch sector
• Settings of conditions for voyage and dangerous targets recordings
• Ship parameters (table of forwarding distance, optimization parameters and navigation parameters)
• Setting for position discrepancy limit
18.3 Usage Rights
A workstation can have different usage rights. Master and Multi (Slave) rights allow control of both planning and
monitoring modes and navigation sensors. Slave (Multi) and Plan usage rights allow only control of the planning
mode. Workstations can be set so that
• One has Master usage rights. The rest has Slave (Multi) or Plan usage rights.
• One has Multi (Slave) usage rights. The rest has Plan usage rights.
18.3.1 Setting usage rights as “master”
One single workstation can be chosen to control the monitoring mode and navigation sensors. This means that this
particular workstation is used to choose route, user chart and pilot data for the monitoring mode.
To choose configuration of system in which one workstation has
usage rights set as Master, do the following:
1. Place the cursor below the chart scale indication, confirm that
Initial Settings is shown in the mouse functions area and then
push the right mouse button.
2. Check the Usage rights box and choose Master from the List
box.
3. The indication MASTER appears at the lower right hand corner
on the chosen workstation.
4. The indication SLAVE appears at the lower right hand corner on
the other workstation.
To Next Page
Loading...
