18. Common Reference System
18-6
18.3.2 Setting usage rights as “multi” or “slave”
Multiple workstations can be chosen to control monitoring modes and navigation sensors. This means that these
particular workstations are used to choose route, user chart and pilot data for monitoring modes. However, the
multiple control requires that none of the other workstations is set for Master usage rights. If the other workstation is
set for Master usage rights, then this workstation can be set only as Slave or Plan. The transition from Slave to Multi
usage right is automatic. If later the usage right selections in the other workstation are changed, then the usage rights
in this workstation is automatically set as Multi or Slave based on non-existence or existence of a Master usage
rights workstation.
To choose configuration of system in which multiple
workstations have usage rights set as Multi, do the
following:
1. Operate at the workstation for which you like to
give Multi or Slave usage rights.
2. Place the cursor below the chart scale indication,
confirm that Initial Settings is shown in the mouse
functions area and then push the right mouse button.
3. Check the Usage rights box and choose either Multi
(Slave) or Slave (Multi) from the List box. First
alternative indicates the selection and second
alternative in parenthesis indicates the provisional
selection. Provisional selection may be used by the
system if new usage rights selections are made in
the other workstation.
4. If, based on your request, you got shared Multi
usage rights, then the indication MULTI appears at
the lower right hand corner of display. If one of the
workstations was already chosen as Master, then the
system cannot give you Multi usage rights. In this
case the indication SLAVE appears at the lower
right hand corner of display.
or
or
SLAVE
To Next Page
Loading...
