21. AIS Target Functions
21-9
21.5 Displaying AIS Interface Status
You can verify the status of the AIS interface on the Other page in the Sensors dialog box. The lower part of this
page is reserved for AIS interface monitoring.
• Received Data: Whether
data from AIS transponder is
correctly received or not
(Status: OK or Error).
• Display: Whether maximum
number of AIS targets set for
display on the ECDIS has
been exceeded within the
defined maximum range or
not (Status: OK or
Overflow).
• Storage: Whether maximum
number of AIS targets for
storage has been exceeded or
not (Status: OK or
Overflow).
n
[Main Menu]
Chart Menu
X
MOB
Event
Record
X
Safety Message
Set Base Display
Initial Settings
Alarms
Arpa+Ais
Sensors
Picture
Mark
Echo
X
Route Monitor
User Chart
X
Pilot Data
X
Radar
Close
Safety Msg Alarm
Received data Ok
Display Ok Storage Ok
Ref tgt
Further, you can enable or disable the alarms “Alarm 3502: Dangerous AIS target” and “Alarm 3503: Lost AIS
target” on this page. Check Danger & Lost Alms on the Other page in the Sensors dialog box if you want alarms for
dangerous and lost AIS targets.
To Next Page
Loading...
