Furuno FM-8800D - Message File Entry

4.3 System Setting: User Menu
4-16
Procedure
1. Select [MENU] -> MEMORY CHANNEL and press [ENT] key.
2. Select a “Memory Channel” and press [ENT] key.
3. Select a mode and press [ENT] key.
4. Select a channel of the mode and press [ENT] key.
How to erase MOMORY CHANNEL
Select a channel to be erase and select “ERASE” press [ENT] key.
4.3.4 MESSAGE FILE ENTRY
When transmitting registered message, press [FILE] -> Select from File List -> [CALL]
key. When transmitting an edited message, you have to press [ENT] key and edit the
content beforehand and press [CALL] key.
How to operate message:
1. The maximum of 100 messages.
2. The only category to register is “ROUTINE”.
3. The message “NAME” to register is a maximum of 16 characters.
4. The only mode channel to register is INTL.
5. Above stated channels are the reflection/display of the state of TRX, DUP/SIMP
and TX POWER of INTL set up by [MENU] -> SYSTEM -> CH CONFIG.
Procedure
1. Select [MENU] -> MESSAGE FILE ENTRY and press [ENT] key. Or, the same
display can be called up by pressing [FILE] key
2. Select a file number to memory and press [ENT] key.
3. Select CALL TYPE and press [ENT] key.
4. Create a message and bring a cursor onto REGIST and press [ENT] key.
* SETUP MENU *
ALARM
AUTO ACK
ERASE LOG
MEMORY CHANNEL
MESSAGE FILE ENTRY
* Memory channel 1/7 *
01: _ _ _ _ _ _ _ _ _ _
02: _ _ _ _ _ _ _ _ _ _
03: _ _ _ _ _ _ _ _ _ _
04: _ _ _ _ _ _ _ _ _ _
05: _ _ _ _ _ _ _ _ _ _
06: _ _ _ _ _ _ _ _ _ _
07: _ _ _ _ _ _ _ _ _ _
08: _ _ _ _ _ _ _ _ _ _
INTL
USA
WX
CANADA
INLND-WA
ERASE
[ENT]
[ENT]
INTL
01
Only for the set CH MODE is shown.
[ENT]