4.4 System Setting: Option Menu
4-22
4.4 System Setting: Option Menu
To call up the option menu, see page 4-1.
4.4.1 AUTO 1W
In case of ON setup, VHF channel output is automatically reduced to 1W.
VHF to control channel is as follow:
- “LOW POWER” channel which is described on VHF channel list.
- A channel which is set up to LOW POWER by [MENU] -> SYSTEM -> CH
CONFIG.
All channels are Hi Power when setting OFF.
Then, the reduced channel by 1W cannot be set up to Hi power even if [0:HI/LO] key is
pressed.
Procedure
1. Select [MENU] -> SYSTEM -> AUTO 1W and press [ENT] key.
2. “ON/OFF” pop-up window will appear. Then, select ON and press [ENT] key.
4.4.2 AUTO REVERD
In case of ON setup, it goes back to CH16 automatically when Transceiver unit Handset
or Remote Handset are back on Hanger. (ON HOOK)
Procedure
1. Select [MENU] -> SYSTEM -> AUTO REVERD and press [ENT] key.
2. “ON/OFF” pop-up window will appear. Then, select ON and press [ENT] key.
4.4.3 CH70 BOARD
This function is not available.
To Next Page
Loading...
