EasyManua.ls Logo

Furuno FMD-3100 - Troubleshooting; C-MAP Dynamic Licensing (DL) Service; Chart Display; Introduction

Furuno FMD-3100
395 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7. C-MAP BY JEPESSEN CHARTS
7-2
7.4 Troubleshooting
If you are having problems installing your software or charts please check the follow-
ing before contacting C-MAP:
Check that the charts are available, with the chart management function.
Check that the license is correctly installed, with the license function
Contact Information: For information please call you're nearest C-MAP Office (de-
tails can be found on the reverse side of the C-MAP chart CO box) or contact C-MAP.
E-mail: technical.marine@c-map.com
7.5 C-MAP Dynamic Licensing (DL) service
The C-MAP DL service is an ENC service available on DVD or online, in C-MAP SENC
format. The C-MAP DL ensures immediate access to ENC licenses whenever they are
needed. ENC licenses available in seconds automatically via online C-MAP service
providers. Cost is controlled via pre-set budgets and spending limits, giving shipown-
ers a true "pay-as-you-go" service. For further details about C-MAP DL, contact a C-
MAP provider.
Note: PC and internet connection with e-mail are required to use the C-MAP DL ser-
vice. Further it is necessary to access C-MAP approx. once every two weeks.
7.6 Chart Display
7.6.1 Introduction
The two type of C-MAP charts can be displayed together. These charts have the pri-
ority order shown below.
1) C-MAP ENC
2) C-MAP PROFESSIONAL+
If the same navigational purpose charts are available over an area, priority is as shown
above. Areas where ENC is not available C-MAP ENC charts are shown. Where C-
MAP PROFESSIONAL+ are available, C-MAP PROFESSIONAL+ charts are dis-
played.
The [Chart Legend] dialog box provides various information about the C-MAP chart
currently displayed. The information can be displayed two ways:
To close the dialog box, click the [Close] button.
For current position: Click the [TM/CU Reset] button while in the Voyage navigation
mode then click the [Chart INFO] button on the InstantAccess bar™ followed by the
[Chart Legend] button.
For a specific location: Put the cursor on the location then right-click and select
[Chart Legend]. Click the [Close] button to close the display.

Table of Contents

Other manuals for Furuno FMD-3100

Related product manuals