2. WIRING
2-31
CH1 settings (RADAR SIGNAL IN NO.1)
Using the table below for reference, change the jumper settings to suit the appropriate
radar connection. Use the figure on the previous page for jumper locations.
CH2 settings (RADAR SIGNAL IN NO.2)
Using the table below for reference, change the jumper settings to suit the appropriate
radar connection. Use the figure on the previous page for jumper locations.
Jumper
Radar to be connected
JMA-9100 series BR-3440 series
J1 #2-3: short
J2 #3-6: short
J3 #2-6: short #1-5: short
J4 #1-2: short
J5 #2-3: short
J6 #3-6: short
J10 #3-7: short #2-6: short
J13 #1-2: short #2-3: short
Jumper
Radar to be connected
FURUNO radars JMA-9100 series BR-3440 series
J7 #2-3: short #1-2: short
J8 #1-2: short #2-3: short
J9 #1-4: short #3-6: short
J11 #2-3: short #1-2: short
J12 #1-2: short #1-2: short
J14 #2-3: short #1-2: short
J15 #2-3: short #1-2: short
J16 #2-6: short #2-6: short #1-5: short
J17 #2-3: short #1-2: short
J18 #1-2: short #2-3: short
J19 #1-4: short #3-6: short
J20 #2-3: short #1-2: short
J21 #2-3: short #1-2: short
J22 #3-7: short #3-7: short #2-6: short
J23 #2-3: short #1-2: short
J24 #1-2: short #1-2: short #2-3: short
To Next Page
Loading...
