4.4 Updating Program
4-12
Updating from FDD
1. Turn off IB-583.
2. Insert the floppy disk containing the latest program into the floppy disk drive.
3. Turn on IB-583.
4. The program runs automatically and the message below appears.
FD BOOT Ver.1.xx
Update IB583 TERM
Boot From FD ? (Yes/No) __
5. Press [Y]. The message below appears.
Loading : Load.bin ____ xx sec
Fs-x570 NBDP Term Software Update
Are you sure update ? (Y/N)
6. Press [Y]. Updating automatically starts.
Now erasing:
Now updating program
Update xx % (last xx sec)
7. When “Update xx%” is turned to be “100%”, the updating is completed. Normal
display appears on IB-583.
8. Turn off the system and on it again.
To check the detail program number;
1) Run “Self test” of [F6] system menu.
2) Press [F1] while holding [Fn] and [Alt] to show the program version in detail.
To Next Page
Loading...
