Furuno FS-2550 - Changing System Settings

DSC-6
B2-4
3.2 Changing System settings
The set up menu appears by pressing the [SELECT] key at the normal display.
Note) To release protection for “9:system” menu.
Set up menu < >
TIME 1 2 3 4 6 7 9 0 ALM
Watch
[SELECT]
Set up menu
I
m
p
ortant !!
[SELECT] [9]
Select "P" and press [ENT]
Enter cypher code;
652111
Select "OFF" and press [ENT].
Now you may reenter the following
* Format of navigator
* DMC-5 connection
* DP-5/6 connection
* Installation type
* TX timming
* AF line out level
After changing the settings, set the "Protection" menu to "ON" for normal operation.
Select "ON" and press [ENT].
Press [CANCEL] several times.
Returns to normal display.
Watch
Watch
System < >
V P ID ----
System < >
V P ID ----
TEST
Protection < >
ON OFF
* System protected *
Protection < >
ON OFF
[SELECT] [9] [ENT][>]
The registered MMSI number is reading only.
If you want to change of MMSI number, refer to section "6. Changing ID number".