Furuno FS-2570 - Scanning; Communication Buffer

11 NBDP TRANSMITTING, RECEIVING
11-12
11.9 Scanning
The radio equipment scans a group of operator-selected frequencies (channels), and stops
scanning when an signal is received. For registering scan group, see paragraph 11.5.
1. Press the function key [F3] and then the [5] key to show the Scanning Group List on
your screen.
You can confirm the scan channel by pressing the [↑] or [↓] key while pressing the [Shift]
key.
*1
2
*3
Scanning Group List
Scanning group list
2. Choose a scan group and press the [Enter] key.
3. The scanning starts and the indication "Scan" appears in reverse video. Further, the
name of the scan group appears in the Station Name field.
Station Name : SAITO-1 Print Scan T.Op HT Scra
Frequency (T/R) : 8344.00 / 8705.00(kHz) Comm Mode : CW
Comm Status : Connect Send Lock Error
Sending Volume : 100(%) ARQ Error : 0 ARQ Time : 0(sec)
02-01-15 02:01 (JST)
1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break
Communication status display
4. To stop scanning, press the function key [F3] and then the [5] key. “Scan” appears in
normal video on the communication status display.
11.10 Communication Buffer
The communication buffer is a temporary memory which stores transmit and receive
messages. To display the contents of the communication buffer, do the following:
1. Escape from the message creation screen.
2. Press the [PgDn] or [PgUp] key. The contents of the communication buffer are
displayed.
To print them, press the [Ctrl] and [P] keys simultaneously. To erase the contents from the
screen, press the [PgDn] key again.
To erase the contents of the buffer, press the [F1] and [9] keys.