1. HOW TO INSTALL THE SYSTEM
1-2
1.1.3 How to install the unit in a console (flush mount)
The flush mount kit is required to install the Control Unit in a console.
Type: OP05-122, Code No.: 001-135-600
1. Make a cutout in the installation location. See the outline drawing.
For the flush mount, select a flat mounting location.
2. Set the Control Unit to the cutout.
3. Attach two mounting metals (supplied) to the Control Unit with two hex bolts
(M6×12, supplied) and M6 spring washers (supplied).
4. Screw the wing bolts and the wing nuts to the mounting metal, then attach the pro-
tectors for screws as below.
5. Fasten each wing bolt so that the protector for screw touches the back side of the
mounting place.
6. Fasten the wing nuts tightly.
Name Type Code No. Qty
Mounting metal 05-089-1171-0 100-299-020 2
Wing bolt M4×40 YBSC2 000-175-263-10 4
Wing nut M4 YBSC2 000-168-239-10 4
Hex. bolt M6×12 SUS304 000-162-897-10 2
Spring washer M6 SUS304 000-158-855-10 2
Protector for screw 26-005-2125-0 100-354-800-10 4
Mounting metal
Wing bolt
Protector for
screw
Wing nut
Mounting metal
To Next Page
Loading...
