1. HOW TO INSTALL THE SYSTEM
1-6
1.3 Transceiver Unit FS-1575T, FS-2575T, FS-5075T
Select a location that meets these conditions:
• Select a location which provides good ventilation.
• The location must be clean and dry.
• Make sure the location can hold the unit under the conditions of continued vibration
and shock normally found on the boat. If necessary, increase the strength the instal-
lation location.
• Follow the compass safety distance shown in the Safety Instructions to prevent the
interference to a magnetic compass.
• Follow the recommended service space shown in the outline drawing to provide
space for maintenance and checking.
• Install the unit away from direct sunlight to prevent overheating.
Fasten the unit with 6×30 self-tapping screws on a bulkhead. Refer to the outline draw-
ing for installation dimensions.
1.4 Handset HS-2003
Unfasten six screws to remove the bracket cover. Fasten the bracket to the location
with two self-tapping screws 4x16 (supplied).
57
77
208
Handset
bracket cover
Screws
65
φ
12 Cable entrance
22
42
2-
φ
4.5
Fixing hole
To Next Page
Loading...
