1. HOW TO INSTALL THE SYSTEM
1-13
4. Make the following connections between the WR2 Board / ANT WR2 / RX-FIL
Board, with the Mini-pin assy. (supplied with this kit) and the connector assy. (sup-
plied with this kit).
5. For FS-2575/5075, if a divider is not connected, fasten the connector assy. with
the locking saddle next to the WR2 Board.
6. Close the shield cover and the Transceiver Unit.
7. For R_ANT and WR2_ANT shared, open the [RT SETUP] menu (see section
3.3.4), select [SETUP] and set [DIVIDER] to [ON].
R_ANT and WR2_ANT antennas shared Separate R_ANT and WR2_ANT
• Connect J2 on WR2 Board to J6 on RX-FIL Board.
Use mini-pin assy. L-380.
• Connect J4 on WR2 Board to J3 on TX Board.
Use mini-pin assy. L-200.
• Connect J5 on RX-FIL Board to J4 on RX-FIL
Board. Use existing mini-pin assy.
• Connect J2 on WR2 Board to ANT WR2. Use
connector assy.
• Connect J4 on WR2 Board to J3 on TX Board.
Use mini-pin assy. L-200.
RX-FIL
Board
J
1 J3 J6
J2 J5 J4
WR2
Board
J2
TX
Board
J4
J3
ANT WR2
J2
WR2
Board
TX
Board
J4
J3
To Next Page
Loading...
