1. HOW TO INSTALL THE SYSTEM
1-14
1.6.9 DUP-FIL Board (FS-5075 only)
The DUP-FIL Board (05P0863) installs above the RX-FIL Board (05P0862A) and
gives the FS-5075 full duplex capability. Parts Name: Full Duplex Kit, Type No. OP05-
125, Code No. 001-135-630
1. Open both the Transceiver Unit and the shield cover.
2. Unfasten the four pcb mounting screws from the RX-FIL Board. See the illustra-
tion below for the location of the Board.
3. Screw in four spacers (supplied) in the pcb mounting screw holes for the RX-FIL
Board.
4. Set the DUP-FIL Board on top of the spacers then fasten the Board to the spacers
with the screws removed at step 2.
5. Make the connections shown below between the DUP-FIL Board and the RX-FIL
Board, using the mini-pin assemblies (supplied).
6. Close the shield cover and the Transceiver Unit.
Name Type Code No. Qty
DUP-FIL Board 05P0863(LF) 001-137-900 1
Mini-pin assy. L-80 000-165-835-10 3
Spacer SQ-15 000-159-299-10 4
RX-FIL
Board
DUP-FIL RX-FIL
Board Board
J1 J3
J2 J4
J3 J8
To Next Page
Loading...
