Furuno FS-2575 - How to Protect Connector, Speaker Jack in Use

1. HOW TO INSTALL THE SYSTEM
1-16
How to protect connector, speaker jack in use
CONNECTOR IN USE SPEAKER JACK IN USE
1) Pass the cable through
the DSUB clamping
plate.
2) Connect the cable to
the control unit. Put the
DSUB boot on the cable,
with the slit on the boot
down.
3) Slide the DSUB boot
downward until it con-
tacts the control unit.
4) Slide the clamping
plate downward until it
contacts the boot. Be
sure there is no gap be-
tween the plate and the
boot.
5) Fasten the plate with
two binding head screws.
(torque: 0.5Nm). Fasten
the boot to the cable with
a cable tie.
1) Pass the cable through
the SPJACK clamping plate.
Note the orientation of the
straight edge on the clamp-
ing plate.
2) Connect the
cable to the
speaker jack. Put
the SPJACK boot
on the cable, with
the slit on the
boot down.
3) Slide the
clamping plate
downward until it
contacts the boot,
with the straight
edge on the plate
down. Be sure
there is no gap
between the plate
and the boot.
4) Fasten the
plate with two
binding head
screws (torque:
0.5Nm).
5) Fasten the boot
to the cable with a
cable tie.
DSUB
clamping
plate
DSUB
boot
Clamping
plate
Cable
tie
SPJACK
clamping
plate
SPJACK
boot
Clamping plate
Cable
tie