2-1
2. WIRING
The illustration on this page and the next two pages show general connections be-
tween the Antenna Coupler, Transceiver Unit, Control Unit and external equipment.
For detailed information, see the interconnection diagram. Many of the cables men-
tioned are JIS (Japan Industry Standard) cables. If not available locally, use the equiv-
alent. See the cable guide in the Appendix for how to select equivalent cables.
FS-1575
RG-10/U-Y
PREAMP
FAX-5
TX/RX ANTENNA
or TX ANTENNA
AUTOMATIC ANTENNA
SWITCH AS-102
RX ANTENNA
3D-2V
RG-10/U-Y
ANTENNA COUPLER
AT-1575
Copper strap
(Connect
to ground.)
05S0952 or 05S0793
DPYC-1.5*
1
(or DPYCY-1.5*
1
)
TTYCS-4*
1
/
TTYCSLA-4*
1
ALARM UNIT
IC-350
NBDP TERMINAL IB-585
TTYCS-1*
1
/
TTYCSLA-1*
1
100/110/200/
220/ VAC
DPYC-6*
1
24 VDC
DPYC-16*
1
AC-DC POWER
SUPPLY UNIT
PR-300
DPYC-6*
1
24 VDC
*
1
:
JIS cable. See Appendix for equivalent cable.
Ground
Wire
GPS NAVIGATOR*
2
(Ex. GP-150)
MATCHING BOX ARD-1 or
ANT. JUNC. BOX AJB1-1A
CONTROL UNIT
FS-2575C
PRINTER
INTERFACE IF-8500
or PRINTER
HANDSET
HS-2003
Ground
Wire
LOUDSPEAKER
TRANSCEIVER UNIT
FS-1575T
05S9351
DSUB15-5P-LxxM
Keyboard (IB-585)
5139U or 5139U BLACK
*
2
:
Connect the GPS navigator to the GNSS port of the transceiver unit.
When you set the AMS mode to [AlertIF1] or [AlertIF2], connect an AMS or sensor adaptor
that can output GPS information to the GNSS port.
Ground
Wire
External Switch
䠄
user supply
䠅
Supplement
ground wire
*3
Supplement
ground wire
*3
*
3
:
It is recommended to add a supplement ground wire (local supply, more than 14 sq.) and
fasten it to the ground terminal of the antenna coupler.
To Next Page
Loading...
