2. WIRING
2-6
AT-1575(In the case of 05P0883-22)
Antenna Coupler AT-1575, inside view (New type board,05P0883-22)
a) Connect the wires from the signal cable to TB5, as shown in
the diagram below.
b) Connect the shield wire from the signal cable to TB4.
c) Unfasten the screws to remove the fixing plate, then connect
the coaxial cable.
d) Secure the shield of the coaxial cable with the fixing plate and screws.
TB5
Version of the board
Fixing plate
Fixing plate
Shield
TB1
COAXIAL CABLE
Shield
Fixing Plate
No. (Color): Name
1 (BRN)䠖㻌ANT
2 (RED)䠖㻌TUNE_OK
3 (ORN)䠖㻌ANT_BK
4 (YEL)䠖㻌TUNE_N
5 (GRN)䠖㻌RX_GND
6 (WHT)㻦㻌15V
7 (BRK)䠖㻌GND
TB5
To Next Page
Loading...
