2. WIRING
2-11
Transceiver Unit FS-5075T, inside view
Note: The inside of the FS-2575T is almost identical to that of the FS-5075T. See the
illustration above for connections.
2.2.2 Power cable
Fabricate the cable DPYC-6
(Max 10 m, FS-1575),
DPYC-10 (Max 10 m, FS-
2575) or DPYC-16 (Max 10
m, FS-5075) as shown be-
low. Attach the crimp-on
lugs supplied on the 24
VDC terminal to the cable.
Connect the cable to the 24
VDC terminal. If an equiva-
lent cable is used it must not
allow the voltage to drop
more than 5%.
Connect shield wire to
ground bar.
Power
cable
Ground bar
Cable
fixing
post
Cable tie
Cable from
Control Unit
Locking wire
saddle
Cable from
Antenna Coupler
Armor
Sheath
Vinyl tape
Set this part in cable clamp.
20 30 20
8 - 10
50
70 (FS-1575T)
150 (FS-2575T,
FS-5075T)
To Next Page
Loading...
