Furuno FS-2575 - 3 Initial Settings; How to Initialize the Control Unit and Transceiver Unit; How to Enter MMSI

3-1
3. INITIAL SETTINGS
This chapter shows you how to enter the initial settings. A password is required to en-
ter the initial settings. Refer to FURUNO Information for the password.
3.1 How to Initialize the Control Unit and
Transceiver Unit
Turn on the power switch on the Control Unit. The equipment starts to update the soft-
ware, in the sequence shown below. When the procedure is completed, the radiotele-
phone screen appears.
3.2 How to Enter MMSI
1. Turn on the Control Unit. Open the Transceiver Unit and press and hold the Reset
switch S1 (approx. 5 seconds) on the T-IF Board (05P0861) until the menu shown
below appears on the Control Unit.
INITIALIZING ..
PLEASE WAIT
*** FS-Controller Download ***
From ver xxxxxxxxxxxxx
To(New) ver xxxxxxxxxxxxx
Erasing ... xx%
*** FS-Controller Download ***
From ver xxxxxxxxxxxxx
To(New) ver xxxxxxxxxxxxx
Erase completed.
Writing... xx%
xxxxxxxxxxxxx=Program version no.
Approx.
70 s
later
Push Reset switch
S1 until the menu
shown below appears
on the Control Unit.
Lock icon
(brown)